SATO CL608e Operation Manual page 49

Operation Manual
Cleaning the Print Head using the Lapping Film (SEG No. 1938)
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Print Head
Lapping Film
CL608e/612e
Cut the lapping film with a pair of scissors or a sharp
knife to 180mm width.
Switch OFF the power to the printer.
Place the lapping film between print head and platen
with the abrasive side face-up. Close the print head
with the head latch.
Pull the cleaning film by hand slowly toward the front
of the printer.
Repeat steps 3 and 4 two or three times.
Finally, clean the print head with a print head cleaner
as described previously.
6. Cleaning and Maintenance
43