SATO CL608e Operation Manual page 39

Operation Manual
Step 10
Green Tab
Print Head
Assembly
Head Latch
Step 11
Step 12
Note:
Media Knob
Feed Roller Assembly Label Unwind Guides
CL608e/612e
If the ribbon is already loaded, close the print head
assembly by pushing downward on the green tab
until it latches closed.
If the ribbon is not loaded, see the following descrip-
tion for loading instructions.
Adjust the print head pressure knob based on the
media you have loaded. For media up to 60mm wide,
use the "1" position (minimum print head pressure),
for media between 60 and 120mm wide, use the "2"
position. For media wider than 120mm, use the "3"
position (maximum print head pressure).
If you use media narrower than 120mm, using
the wrong setting will apply excessive pressure
to the print head and may void the print head
warranty.
4. Media Loading
Label Roll
Support
33