Default Settings - SATO CL608e Operation Manual

Operation Manual
3.2

Default Settings

Switch Selections
All switches except DSW2-5 are placed in the OFF position
(default) for shipping. This will result in the following operating con-
figuration:
• Communications:
• Protocol:
• Sensor:
• Receive Buffer:
• Mode:
• Pitch:
• Back feed:
• External Signals:
Software Default Settings
The printer stores the software settings upon receipt and uses
them until they are again changed by receipt of a command con-
taining a new setting. These settings are stored in non-volatile
RAM and are not affected by powering the printer off. The printer
may be reset to use the default software settings by depressing the
LINE and FEED keys simultaneously while powering the printer on.
This will result in the following default configuration:
• Print Darkness:
• Print Speed:
• Print Reference:
• Zero:
• Auto On Line:
• Ignore CR/LF:
• Character Pitch:
• Auto Online Feed:
• Feed On Error:
• Repeat Print:
• Forward/Backfeed:
• Select Language:
• Priority Setting:
CL608e/612e
8 data bits, no parity, 1 Stop bit, 9600 Baud
Ready/Busy
Gap Sensor
Multi Job
Batch/continuous
Sensor Used
Enabled
Disabled
"2"
6 inches per second
Vertical = 0000, Horizontal = 0000
Slash
Enabled
Disabled
Proportional
Disabled
Disabled
Disabled
Standard
English
Command
3. Configuration
25