Replacing The License Plate Light Bulb - Yamaha XJ6SA Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
6
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
Replacing the license plate
1
light bulb
1. Remove the license plate light unit
by removing the screws.
1. License plate light unit
2. Screw
2. Remove the license plate light bulb
[ECA11191]
socket (together with the bulb) by
pulling it out.
EAU24313
1
1. License plate light bulb socket
2. License plate light bulb
2
3. Remove the burnt-out bulb by pull-
4. Insert a new bulb into the socket.
5. Install the socket (together with the
6. Install the license plate light unit by
6-39
ing it out.
bulb) by pushing it in.
installing the screws.
1
2