Yamaha XJ6SA Owner's Manual page 60

PERIODIC MAINTENANCE AND ADJUSTMENT
1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
4. Add coolant to the maximum level
mark, and then install the coolant
reservoir cap. WARNING! Re-
6
move only the coolant reservoir
cap. Never attempt to remove
the radiator cap when the en-
gine is hot.
[EWA15161]
coolant is not available, use dis-
tilled water or soft tap water in-
stead. Do not use hard water or
salt water since it is harmful to
the engine. If water has been
used instead of coolant, replace
it with coolant as soon as possi-
ble, otherwise the cooling sys-
tem will not
against frost and corrosion. If
water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
2
the coolant as soon as possible,
3
otherwise the effectiveness of
the coolant will be reduced.
[ECA10472]
Coolant reservoir capacity (up to
the maximum level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
5. Route the coolant reservoir breath-
er hose through the guide as
shown.
NOTICE: If
1. Coolant reservoir breather hose
2. Guide
be protected
To change the coolant
1. Place the vehicle on the center-
2. Remove cowlings A and C. (See
3. Place a container under the engine
4. Remove the radiator cap retaining
1
2
1. Radiator cap
2. Radiator cap retaining bolt
3. Radiator cap retainer
6-15
stand.
page 6-8.)
to collect the used coolant.
bolt, radiator cap retainer and radi-
ator cap. WARNING! Never at-
tempt to remove the radiator
cap when the engine is hot.
[EWA10381]
1
EAU47573
2
3