Seat; Helmet Holder - Yamaha XJ6SA Owner's Manual

Seat

To remove the seat
1. Insert the key into the seat lock,
and then turn it counterclockwise.
2
1
1. Seat lock
2. Unlock.
2. While holding the key in that posi-
tion, lift the rear of the seat up, and
then pull the seat off.
To install the seat
1. Insert the projection on the front of
the seat into the seat holder as
shown.
INSTRUMENT AND CONTROL FUNCTIONS
EAU32980
1
2
1. Projection
2. Seat holder
2. Push the rear of the seat down to
lock it in place.
3. Remove the key.
TIP
Make sure that the seat is properly se-
cured before riding.

Helmet holder

1. Helmet holder
2. Owner's tool kit
3. Helmet holding cable
The helmet holder is located under the
seat. A helmet holding cable is provid-
ed in the owner's tool kit to secure a
helmet to the helmet holder.
To secure a helmet to the helmet
holder
1. Remove the seat. (See page
2. Pass the helmet holding cable
3-18
2
1
3-18.)
through the buckle on the helmet
strap as shown, and then hook the
cable loops over the helmet hold-
er.
EAU46751
3
3