Yamaha XJ6SA Owner's Manual page 61

5. Remove the coolant reservoir
breather hose from the guide, and
then remove the coolant reservoir
cap.
1
1. Coolant reservoir cap
2. Coolant reservoir breather hose
3. Guide
6. Remove the coolant reservoir cov-
er and coolant reservoir by remov-
ing the bolts.
PERIODIC MAINTENANCE AND ADJUSTMENT
2
3
1. Bolt
2. Coolant reservoir cover
3. Coolant reservoir
7. Drain the coolant from the coolant
reservoir by turning it upside down.
8. Remove the coolant drain bolt and
its gasket to drain the cooling sys-
tem.
1. Coolant drain bolt
2. Gasket
1
2
3
1 2
6-16
9. After the coolant is completely
drained, thoroughly flush the cool-
ing system with clean tap water.
10. Install the coolant drain bolt and its
new gasket, and then tighten the
bolt to the specified torque.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
11. Install the coolant reservoir and its
cover by placing them in the origi-
nal position, and then installing the
bolts.
12. Pour the specified amount of the
recommended coolant into the ra-
diator and reservoir.
6