Yamaha XJ6SA Owner's Manual page 27

Right
1. Engine stop switch " / "
2. Start switch " "
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " / "
Set this switch to " " for the high
beam and to " " for the low beam.
Turn signal switch " /
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
INSTRUMENT AND CONTROL FUNCTIONS
position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
the engine. Set this switch to "
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
EAU12350
or when the throttle cable is stuck.
Start switch "
EAU12400
Push this switch to crank the engine
with the starter. See page 5-1 for start-
ing instructions prior to starting the en-
gine.
EAU12460
"
The engine trouble warning light and
ABS warning light may come on when
the key is turned to "ON" and the start
". When re-
switch is pushed, but this does not indi-
cate a malfunction.
Hazard switch "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12500
" turn signal lights).
The hazard lights are used in case of
an emergency or to warn other drivers
EAU12660 when your vehicle is stopped where it
/ "
might be a traffic hazard.
" before starting
" to
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU12711
"
EAU42341
3-12
EAU12733
"
" posi-
3
ECA10061