Installing The Appliance - Westinghouse PSP632 User Manual

INSTALLATION

INSTALLING THE AppLIANCE

CAbINET REqUIREMENTS
This appliance has been designed to 'slot-in' to a 600mm
wide gap built-in standard kitchen cabinets. As such the
appliance can be installed matching the height and depth of
benches and behind the kick rail of the cabinets. This allows
the cooker to integrate well into contemporary kitchens. The
cooker may also be installed at the end of a line of benches or
with a free space on either side.
• This appliance is not supplied with a splashback.
• Ensure that all vertical surfaces (rear and sides) are non-
combustible surfaces (eg ceramic tiles, sheet metal or
toughened glass).
• Refer to section 5.12.1.1 of AS5601 in Australia or
section 14.1.2 of NZS5261 in New Zealand for
overhead clearances.
WARNING
This appliance has been tested and approved to the relevant Australian
Standards. It is designed to cook food, it will get hot. Cabinet materials
must be capable of withstanding 85
tolerant cabinetry (eg vinyl coated) may result in deterioration of the low
temperature coating by discolour or bubbling.
Electrolux Home Products cannot accept responsibility for
damage caused by installation into low temperature tolerant
cabinets.
C. Installation into lower temperature
o
RECOMMENDED CAbINET DESIGN
m
6 0 0 m
m m
6 0 0
INSTALLATION SEqUENCE
1. Check that the required services are correctly positioned
(see electrical and gas services requirements section and
cabinet requirements section).
2. Ensure that cabinetry has correct details (see cabinet
requirements section).
3. Unpack the cooker.
4. Remove the foam pack containing accessories.
5. Remove the internal pack from the oven and position shelf
supports and grill trays (see page 5).
6. On gas cookers position gas burners and trivets (see
page 6).
6 0 0 m
m
m in im
u
m
)
M
N O
m (
m
9 0 0
)
M
N O
m (
m
0
7 2
anti-tilt bracket