Installing The Appliance; 600Mm - Westinghouse WFE616 User Manual

INSTALLING THE APPLIANCE

(600mm wide product)
Cabinet requirements
This appliance has been designed to 'slot-in' to a 600mm
wide gap built-in standard kitchen cabinets. As such the
appliance can be installed to suit the height of the benches
This allows the cooker to integrate well into contemporary
kitchens. The cooker may also be installed at the end of
a line of benches or with a free space on either side.
• Electric hob models must not be installed in a corner;
they must be installed at least 100mm from the
side wall. Gas hob models must be installed with a
minimum clearance of 100mm to side walls made
of unprotected combustible materials.
• For gas models refer to section 6.10.1 in AS/NZS
5601.1 for all relevant clearances.
WARNING
WARNING
This appliance has been tested and approved to the
relevant Australian Standards. It is designed to cook
food, it will get hot. Cabinet materials must be capable
of withstanding 85
tolerant cabinetry (e.g. vinyl coated) may result in
deterioration of the low temperature coating by discolour
or bubbling.
Electrolux Home Products cannot accept responsibility
for damage caused by installation into low temperature
tolerant cabinets.
Installation and service warning
WARNING
WARNING
• Only an authorised person must install and
service this appliance (Certificate of Compliance
to be retained).
• In order to avoid a hazard, the installation
instructions MUST be followed.
• In order to avoid the appliance tipping, the anti-tilt
plate MUST be installed.
• Appliances requiring connection to 230 – 240V
MUST be earthed.
• An authorised person should inspect this appliance
every 5 years.
• This appliance must NOT be installed on a base,
box or in a closed cupboard.
• If the electrical supply cord is damaged, a qualified
person MUST replace the cord to avoid a hazard or
void your warranty.
26
INSTALLATION
C. Installation into lower temperature
o
Recommended cabinet design
630mm
596mm minimum
Preparing for installation
1. Check that the required services are correctly
positioned (see electrical and gas services
requirements section and cabinet requirements
section).
2. Ensure that cabinetry has correct details (see cabinet
requirements section).
3. Unpack the cooker.
4. Remove the foam pack containing accessories.
5. Remove the internal pack from the oven and position
shelf supports and grill trays.
6. Remove the 2 screws for the splashback from the
rear panel, and fit it to the unit with the same screws.
Clearance to side wall
(refer notes)

600mm

600mm
minimum
900mm (NOM)
720mm (NOM)
910mm minimum
anti-tilt plate
1.25m electrical
service cord (if fitted)