Installing The Car Seat On The Base - Peg-Perego Primo Viaggio Owner's Manual

Installing the Car Seat
Important!
Do not use this child restraint
in your vehicle without the base.
Now that you have installed the base
in your vehicle, you are ready to
install the car seat on the base.
1. Holding the car seat by the handle, press
it rear facing on the base until you hear
the click. You will not be able to move the
car seat if it is properly locked in place.
Check to make sure the base is still level.
If not, remove the car seat and adjust the
base until the ball is in the green area.
Important!
Newborn infants should
recline slightly. If the seat reclines too
much, your baby can be ejected from the
seat in an accident. If too upright, it can
cause breathing problems.
on the Base
21