Installing The Base - Peg-Perego Primo Viaggio Owner's Manual

Installing the Base

The Peg Perego Primo Viaggio car seat has two major parts:
The base and the car seat. First you install the base, and then
you install the car seat on the base.
Important!
Read your vehicle manual for instructions on where
to best install an infant car seat in your vehicle.
There are two ways to install the base:
1
Using the LATCH system. If your car has "universal lower
anchors," you can install the infant car seat using the LATCH
system instructions on page 12. The anchor is a bar located
where the seat back meets the seat bottom. (Slide your hand
down between the seats to locate this bar.)
Important!
on using the LATCH system.
2
Using the standard lap belt/shoulder strap. If your car does
not have universal lower anchors, install the infant car seat using
the instructions for lap belt/shoulder straps on page 15.
Also read your vehicle manual for instructions
11