Installing The Car Seat On The Base - Peg-Perego PRIMO VIAGGIO SIP ES 30.30 Owner's Manual

Now that you have installed the base in
your vehicle, you are ready to install the
car seat on the base.
1• Holding the car seat by the handle,
press it rear facing on the base
until you hear the click. You will not
be able to move the car seat if it
is properly locked in place. Check
to make sure the base is still level.
If not, remove the car seat and
properly adjust the base.
Important! Newborn infants should be
properly reclined. If the seat reclines too
much, your baby can be ejected from
the seat in an accident. If too upright, it
can cause breathing problems.
PrimoViaggioSIP-ES_USA_30-30_FIU23 23

Installing the Car Seat on the Base

23
10-03-2010 14:44:56