Initial Startup - Hayward EcoStar SP3400VSP Owner's Manual

c. MAX Allowed Speed
d. MIN Allowed Speed
e. Set max-speed Prime Period
f. Remote Control Mode
g. Set COMM Bus Address
2. Timer Menu (see section 5.7)
a. Rename Timer X (X = 1-8)
b. Pump Speed for Timer X (X = 1-8)
c. Start/Stop Time for Timer X (X = 1-8)
d. Choose Days for Timer X (X = 1-8)
3. Speeds Menu (see section 5.8)
a. Speed X Name (X = 1-4)
b. Speed X Duration (X = 1-4)
c. Speed X Speed (X = 1-4)
4. Diagnostics Menu (see section 5.9)
a. Drive Serial Number
b. Motor Drive/Display Firmware Revisions
c. Input Voltage Status
d. Motor Current
e. Power Usage
f. Driver/Heatsink Temperatures
g. COMM Bus Status
h. Event Log (if applicable)

5.5. Initial startup

After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is
applied to the drive for the first time, the following informational screens are displayed.
1.
Hayward EcoStar Pump
SP3400VSP
2.
Thursday
0rpm
3.
Pump is stopped
Factory default op.
Note: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive
configuration and timers be set according to individual installation site requirements (see section 10 for more
details). After the configuration/timer settings are changed, "Factory default Op." is replaced by "No timers are set".
At this point, pressing the MENU button will select the Configuration Menu.
Page 17 of 32
Screen
1:27p
26 Watts
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
EcoStar Variable Speed Pump
Comments
Pump SKU will be shown at the bottom of the screen.
IS3400VSP Rev-B