Initial Startup; Configuration Menu - Hayward LifeStar VS Owner's Manual

6.5. Initial startup

After plumbing and wiring are complete, the variable speed drive must be configured prior to use.
When power is applied to the drive for the first time, the following informational screens are displayed.
1.
Hayward EcoStar Pump
screen.
SP3400VSP
2.
Thursday
1725rpm
3.
Timer 1 timer
will end at 11:45p
Note: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that
the drive configuration and timers be set according to individual installation site requirements (see
section 6.7 for more details). At this point, pressing the MENU button will select the Configuration
Menu.

6.6. Configuration Menu

1.
Configuration Menu
to
2.
Configuration Menu
press > to enter
3.
Use + / - to adjust,
> go to next item
4.
Time:
+ change
5.
Set Day and Time
Thursday
_____________________________________________________________________________________
Hayward Flow Control
Screen
1:27p
380 Watts
Screen
Locked
Th 1:27PM
or > skip
1:27p
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
www.haywardflowcontrol.com
Comments
Pump SKU will be shown at the bottom
Note: Screen Information will not
display Hayward LifeStar® Pump
1A3SES46VS. This will not affect the
operation of this pump.
Buttons
Used Comments
< > Press & hold < and > buttons for several seconds
unlock Configuration Menu
< > Use > to enter Configuration Menu
+ - Use + to change clock setting
< > Use > if clock is correct
+ - Adjust day/time setting
< > Move to next selection, then to next menu item
1-888-HAY-INDL (1-888-429-4635)
IS3401VSPFC Rev A 12/08/14
Pg. 22 of 36