Table of Contents
Advertisement
Preset Speed Setup Menu (see page 20 to program the 4 preset speeds)
3.
a.
Speed "X" Name (where "X" equals 1 through 4)
b.
Speed "X" Speed (where "X" equals 1 through 4)
4.
Diagnostics Menu (see page 21 to view product diagnostic information)
a.
Display Firmware Revision
b.
Drive Serial Number
c.
Motor Drive Firmware Revisions
d.
Event Log (if applicable)
Initial startup
After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is applied to the drive for the first time, the fol-
lowing informational screens are displayed.
Screen
Hayward Variable
1.
Speed Pump
Thursday
2.
1725rpm
380 Watts
Timer 1 timer
3.
will end at 11:45p
NOTE: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive configuration and timers be set according to
individual installation site requirements (see page 19 for more details). At this point, pressing the MENU button will select the Configuration Menu.
Configuration Menu
Screen
Configuration Menu
1.
Locked
Configuration Menu
2.
press > to enter
press +/- to change
3.
or > view next item
Display Language
4.
English
Time:
Th 1:27PM
5.
+ change
or > skip
17
1:27p
Buttons Used
< >
< >
+ -
< >
+ -
< >
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Comments
Press and hold < and > buttons for several seconds to unlock the Configuration
Menu.
Use the > button to enter the Configuration Menu.
Select language for all displayed messages.
Move to next menu item.
Use + button to change clock setting.
Use > if clock is correct.
Advertisement
Table of Contents
