Initial Startup - Hayward TriStar SP3215VS Owner's Manual

Initial Startup

After plumbing and connection is complete, the VSD must be configured prior to use. When power is applied to the
drive the four informational screens below are displayed in order from left to right.
Power
8 8 8 8 8
V1 V2 V3
This is shown on the
screen when the pump is
powered up.
Note: If the Prime Mode is disabled, after informational screens 1 and 2 the standard running screen for speed V3
will be displayed bypassing informational screens 3 and 4.
By pressing the DISP/FUNC button during the Priming Cycle you will be able to scroll through the screens shown
below in order from left to right.
Power
- 3 0 0 0
V1 V2 V3
This is the screen that
is automaticly displayed
for Prime Mode and is
displaying pump rpm.
Once the Priming Cycle has finished and the pump is operating in any speed from V1 through V3 by pressing the
DISP/FUNC button you will be able to scroll through the screens shown below in order from left to right.
Power
3 0 0 0
V1 V2 V3
This is the default rpm
screen for speeds V1, V2
and V3 displaying real
time rpm.
Page 7
Power
- r 2 0 -
V1 V2 V3
This is the second screen
displayed and shows the
motor software revision.
Power
P r 2 0 0
V1 V2 V3
Press DISP/FUNC button
once and the Prime Time
remaining is displayed
with the time decreasing.
Power
h 5 0 0
V1 V2 V3
Press DISP/FUNC button
once and the time
remaining for that speed
is displayed.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
TriStar Variable Speed Pump
Power
P r
V1 V2 V3
This screen is only
displayed If Prime Mode
is activated.
Power
P 8 0
V1 V2 V3
Press DISP/FUNC button
again and the power
being used is displayed
in Watts (±10%).
Power
1 4 5 0
P
V1 V2 V3
Press DISP/FUNC button
again and the power
being used is displayed
in Watts (±10%).
Power
- 0
V1 V2 V3
When Prime Mode is
active this screen ramps
up to 3000rpm with
a rotating circle in block 1
Power
- 3 0 0 0
V1 V2 V3
Press DISP/FUNC button
again and the display
returns to the first
screen showing rpm.
Power
3 0 0 0
V1 V2 V3
Press DISP/FUNC button
again and the display
returns to the first
screen showing rpm.
30-LITINSB004 Rev-B