Initial Startup; Configuration Menu - Hayward TriStar VS 950 Owner's Manual

6.5. Initial startup

After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is
applied to the drive for the first time, the following informational screens are displayed.
1.
Hayward Variable
Speed Pump
2.
Thursday
1725rpm
3.
Timer 1 timer
will end at 11:45p
Note: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive
configuration and timers be set according to individual installation site requirements (see section 6.7 for more
details). At this point, pressing the MENU button will select the Configuration Menu.

6.6. Configuration Menu

1.
Configuration Menu
2.
Configuration Menu
press > to enter
3.
Use + / - to adjust,
> go to next item
4.
Time:
+ change
5.
Set Day and Time
Thursday
6.
Speed Selection
7.
MAX allowed speed
3250 (600-3450rpm)
8.
MIN allowed speed
600 (600-3450rpm)
Page 20 of 36
Screen
1:27p
380 Watts
Screen
Locked
Th 1:27PM
or > skip
1:27p
rpm
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
TriStar VS 950 Variable Speed Pump
Comments
Pump SKU will be shown at the bottom of the screen.
Buttons
Used Comments
< >
Press & hold < and > buttons for several seconds to
unlock Configuration Menu
< >
Use > to enter Configuration Menu
+ -
Use + to change clock setting
< >
Use > if clock is correct
+ -
Adjust day/time setting
< >
Move to next selection, then to next menu item
+ -
Select whether to display speed in rpm (Revolutions
per Minute) or % of full speed
< >
Move to next menu item
+ -
Set maximum running speed of pump
< >
Move to next menu item
+ -
Set minimum running speed of pump
< >
Move to next menu item
IS32950VSP Rev B