Menu Outline; Initial Startup - Hayward TriStar VS 900 Owner's Manual

6.4. Menu Outline

Configuration Menu (see section 6.6 for basic product configuration)
1.
a. Set Day and Time
b. Speed Selection
c. MAX Allowed Speed
d. MIN Allowed Speed
e. Prime Duration
f. Remote Control Mode
g. Low Temp Operation
h. Low Temp Setting
2. Timer Menu (see section 6.7 to program the 8 speeds with timer functions)
a. Rename Timer "X" (where "X" equals 1 through 8)
b. Pump Speed for Timer "X" (where "X" equals 1 through 8)
c. Start/Stop Time for Timer "X" (where "X" equals 1 through 8)
d. Choose Days for Timer "X" (where "X" equals 1 through 8)
3. Preset Speed Setup Menu (see section 6.8 to program the 4 preset speeds)
a. Speed "X" Name (where "X" equals 1 through 4)
b. Speed "X" Duration (where "X" equals 1 through 4)
c. Speed "X" Speed (where "X" equals 1 through 4)
4. Diagnostics Menu (see section 6.9 to view product diagnostic information)
a. Display Firmware Revision
b. Drive Serial Number
c. Motor Drive Firmware Revisions
d. DC Bus Voltage Status
e. Motor Current
f. Power Usage
g. Driver Temperature
h. Event Log (if applicable)

6.5. Initial startup

After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is
applied to the drive for the first time, the following informational screens are displayed.
1.
Hayward Variable
Speed Pump
2.
Thursday
1725rpm
3.
Timer 1 timer
will end at 11:45p
Note: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive
configuration and timers be set according to individual installation site requirements (see section 6.7 for more
details). At this point, pressing the MENU button will select the Configuration Menu.
Page 21 of 36
Screen
1:27p
380 Watts
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
TriStar VS 900 Pump
Comments
IS32900VSP Rev-B