Custom Engineering s'print User Manual page 16

1. INSTALLATION AND USE
Note: These parameters listed in the setup, are present only from the Firmware BlueTooth release 1.02
(13)
(FW ); in the previously version are not reported.
Note : In the printer label version (s'print-LP1 model) this parameter is not indicated because the
(14)
alignment is always enabled.
The printer's configurable parameters are :
• Interface: BlueTooth
• Name ID (15) : NO ID
• Authentication (16) : Enabled, Disabled
• Object Push Profile
• Baud Rate : 38400, 19200, 9600
(18)
• Data length : 7, 8
(18)
• Parity : None , Even or Odd.
(18) D
• Hanshaking : XON/XOFF
(18)
• Autofeed : CR Disabled
• Battery: 1000 mAh, 1100 mAh, 1200 mAh, 1300 mAh, 1400 mAh, 1500 mAh, 1600 mAh, 1700 mAh,
1800 mAh, 1850 mAh
• Standby: 1min, 5min
• Print mode: Normal
• Alignment : Disabled
(14)
• Print Density: -2, -1, 0
Please note: The parameters marked with the symbol
If Bluetooth interface is enabled, it's better do not send data on RS232 line, because data
could overlap Bluetooth wireless line.
SETUP DEFAULT :
Test = OK
NAME = S'print-BT
PIN = 12345
ADDR = 00:0E:6D:CE:39:8D
HEAD TEMP. [°C] = 27.5
BATT TEMP. [°C] = 25
HEAD VOLT [V]
Interface
Name ID
Authenticat
Obj Push Pr
Autofeed
Battery
Standby
Print mode
Alignment
Print Density : 0
[PUSH] ENTER SETUP
[FAST PUSH] EXIT SETUP
, RS232.
D
D , #0, #1, #2, #3, #4, #5, #6, #7, #8, #9.
D .
: Enabled, Disabled
(13) (17)
D , 4800, 2400, 1200, 600.
D bits/car.
or Hardware.
D
D or CR Enabled.
D , Alkaline.
D , 10 min, 30 min, 1 h, 2h, None.
, Reverse.
D
, Enabled.
D
D , +1, +2.
1- 7
(13)
= 6.2
: Bluetooth
: NO ID
: Enabled
(13)
: Enabled
: CR Disabled
: 1700 mAh
: 5 MIN
: Normal
(14)
: Disabled
D .
D represent the default values.
DPT100-B/I/BT
(Fig.1.10)