Operating Convenience Features; Display Brightness Control; Keypad Beep Frequency/Level - Yaesu FT-920 Operating Manual

Operating Convenience Features

Display Brightness Control

The FT-920 is shipped from the factory with the dis-
play illumination set to its maximum level. Should you
wish to reduce the illumination level of the display,
use the following procedure.
Press the [M
of operation.
Rotate the VFO-B Tuning Dial to select Menu
Item U-08 ("D
Press the [E
mand" mode.
Rotate the VFO-B Tuning Dial to change the
setting indicated in the main display window
from "O " to "O
FF
Press the [M
Menu mode and resume normal transceiver
operation.
40
] key to enter the Menu mode
ENU
").
IMMER
] key to enter the "Menu Com-
NT
."
N
] key once more to exit the
ENU

Keypad Beep Frequency/Level

The "Beep" tone which is heard when you press a
key on the front panel may be adjusted, if you like.
To adjust the Beep Frequency:
Press the [M ] key to enter the Menu mode
ENU
of operation.
Rotate the VFO-B Tuning Dial to select Menu
Item U-06 ("B -F").
EEP
Press the [E ] key to enter the "Menu Com-
NT
mand" mode. At this point, the current beep
tone frequency will be heard.
Rotate the VFO-B Tuning Dial to set the tone
that you prefer. Just for your information, the
exact tone frequency will be shown on the main
display window.
Once you have found a satisfactory tone, press
[E ] to exit the Menu mode and resume nor-
NT
mal operation.
To set the Beep Level, you may adjust the Beep level
potentiometer, which is accessible through a small
adjustment hole on the bottom of the transceiver. Use
a small insulated flat-blade alignment tool to set the
level to the best amplitude for your operating needs.
FT-920 Operating Manual