Yaesu FT-920 Operating Manual page 76

U-09 (
Function: Selection of display Multi-Panel charac-
teristics
Available Values:
Default:
This Menu Item allows you to choose which selec-
tion will be displayed in the small Multi Panel, located
immediately to the right of the VFO-A frequency dis-
play. The choices are:
Display of the Clarifier offset (in kHz)
from the VFO-A frequency.
Display of the CW Pitch (in Hz)
Display of the amount of frequency dif-
ference between VFO-A and VFO-B.
U-10 (
Function: Selection of Enhanced Tuning Scale
choices
Available Values:
Default:
The Enhanced Tuning Scale, located immediately
above the VFO-A frequency display, may be used to
provide a visual indication of several transceiver op-
erating characteristics:
When the Clarifier is active, a small dot
below the horizontal Enhanced Tuning
Scale shows the relative offset of the
Clarifier from the displayed VFO-A fre-
quency. Note that this small dot will be
observed on Receive when the R
Clarifier is on, but only on transmit
when the T
When the DSP is On, this scale pro-
vides a relative indication of the band-
width currently set via the High-Cut and
Low-Cut knobs.
In this mode, an arrow indicates which
direction you should tune on CW in
order to center an incoming tone on
the "zero beat" point with your own sig-
nal.
When tuning in steps less than 10 Hz,
this scale will expand rapidly as you
tune quickly, but as you tune slowly you
will be able to measure frequency
steps as fine as 1 Hz, thanks to the 1
Hz calibration dots on the Enhanced
Tuning Scale. This feature will be dis-
74
)
/ /
)
/ / /
Clarifier is on.
X
abled when tuning steps are 10 Hz or
larger.
U-11 ( )
Function: Select the number of Memory Channels
in Group 1
Available Values:
Default: (All Memory Channels are in Group 1 by
default)
Memory Group 1 may be left at 99 channels, in which
case there will be no partitioning of the Memory Sys-
tem. Otherwise, you may set any number less than
99 for inclusion in Group 1 if you wish to partition the
memories.
U-12 ( )
Function: Select the number of memories in Group 2
Available Values: The last digit in Group 1 plus 1 is
the bottom end of Group 2; 99 maximum
Default:
If, for example, there are 25 memories in Group 1,
Group 2 starts at Memory #26.
U-13 ( )
Function: Select the number of memories in Group 3
Available Values: The last digit in Group 2 plus 1 is
the bottom end of Group 3; 99 maximum
Default:
If, for example, Group 2 contains Memory Channels
26 through 40, Group 3 begins with
X
Memory #41.
U-14 ( )
Function: Select the number of memories in Group 4
Available Values: The last digit in Group 3 plus 1 is
the bottom end of Group 4; 99 maximum
Default:
You do not have to use all 99 memories. Just set the
upper limit of this Menu Item to some value less than
99.
~
FT-920 Operating Manual