(Channel #C-01 To C-11) - Yaesu FT-920 Operating Manual

(Channel #C-01 to C-11)

The "C " channels are easy-access memories
ALL
which may serve as convenient starting points for
operation. Many operators use them for quick recall
of favorite frequencies in each band.
There is no requirement that you assign one fre-
quency per band. However, the C
ture includes a simple method of recalling these spe-
cial memories (described later) which involves the
pressing of one of the [B
procedure for storing memories band-by-band will be
described below for illustrative purposes.
Storing Data in C Channels
ALL
While operating on VFO-A, select the "favorite fre-
quency" you wish to have stored as your "C
frequency on the current band.
Press the [V M] key once momentarily; the
"M CK" indicator will blink, and the frequency store
in the current memory channel will be shown in
the VFO-B display area.
Now press either the [U
use the VFO-B Tuning Dial by pressing the
[M C ] key first) to select the C
EM H
memory assigned to the band currently in use.
See the table below for a listing of the bands and
their assigned memory locations for the C
Channel function. The C
signed memory locations "C-01" through "C-11."
Next, press and hold in the [V
second (until you hear the double beep) to lock
the frequency into the chosen memory location.
You may now repeat this process for the other
C Channels, preferably assigning one such
ALL
channel per band.
Note: Channel "C-10" already is programmed (at
the factory) with the following frequency:
C-10: 51.000.00MHz (FM)
Recall of C Channel Memories
ALL
Whether in VFO or Memory operation, recall of
Channels is very easy. Just press and hold
C
ALL
FT-920 Operating Manual
Channel fea-
ALL
] keys. Therefore, the
AND
"
ALL
] or [D ] key (or
P OWN
Channel
ALL
ALL
Channels are as-
ALL
M] key for ½
in the [S ] key (below and to the left of the VFO-
TEP
A Tuning Dial) and press the [B
keypad) corresponding to the desired band.
For example , to recall the 40-meter C
nel, press and hold in [S
[7 MHz] key while you are holding in [S
recall the 12-meter C
ALL
in [S ] and press [24.5 MHz].
TEP
Note: If you are operating in the "Memory Tune"
mode, activating the C
cancel the Memory Tune function, and place the
transceiver directly into the Memory mode.
Since the C Channels are not segregated into
ALL
an isolated memory band, like the QMB memo-
ries, you also may access these memories via the
[U ] and [D ] keys, or via the VFO-B Tun-
P OWN
ing Dial, as with "regular" memories.
When operating on a C
to utilize the Memory Tune mode in a manner simi-
lar to that used on "regular" memories. Just ro-
tate the VFO-A Tuning Dial, as desired, to tune
off of the pre-programmed C
quency. The new frequency may be stored in an-
other memory, if desired, as described on page
60.
To cancel Memory Tune operation, press the
[VFO/M ] key once (or press and hold in [S
EM
and press another [B
AND
Channel).
Adding Alpha-Numeric Labels to
Memory Channels
Each of the memory channels in the FT-920, except
] key (on the
AND
Chan-
ALL
], then press the
TEP
]. To
TEP
Channel, press and hold
Channel system will
ALL
Channel, it is possible
ALL
Channel fre-
ALL
]
TEP
] key for another C
ALL
63