Yaesu FT-920 Operating Manual page 75

U-01 ( )
Function: VFO-A/VFO-B Tuning Dial Speed
/
Available Values:
Default:
You may choose between two speeds for the tuning
dials. Selecting " " cuts the tuning rate in half com-
pared to the default value.
U-02 ( )
Function: U /D Switch Steps (front panel)
P OWN
Available Values: ~
Default: kHz/Step
The default value is ideal for quick navigation from
one end of a band to the other. For quick tuning
around within a band segment, a value like 1 kHz
may be preferable.
U-03 ( )
Function: S Switch Function
TEP
/
Available Values:
Default:
The (Lock) position allows toggling of the Fast
Þ Fine Þ Normal tuning rate. If
you must hold the [S ] key in while the "Fast" or
TEP
"Fine" indicator is illuminated in order for those tun-
ing rates to be chosen. After releasing the [S
the tuning rate will return to "Normal."
U-04 ( )
Function: Activation/Setting of Magnitude of Quick Split
Available Values: or
Default:
If the Quick Split Menu Item is set to anything other
than Off, pressing the [A K B] key will put the trans-
ceiver in the "Split" mode, with T
on VFO-A. Additionally, a frequency offset (referenced
to the R frequency) will be applied, per your setting
X
of this Menu Item.
U-05 ( )
FT-920 Operating Manual
(kHz/Step)
is chosen,
] key,
TEP
~ kHz
on VFO-B and R
X X
Function: Activation/De-activation of T
[S ] key is pushed
POT
Available Values: /
Default:
Normally, pressing the [S
POT
hear an audible tone corresponding to the pitch of
your own transmitted signal (in the CW mode). By
setting this Menu Item to On, however, you can also
cause the FT-920 to transmit when the [\
pressed.
U-06 ( )
Function: Setting of Key Beeper Frequency
Available Values: or
Default: Hz
The Menu Item allows you to set the tone of the front
panel key Beep tone generator to whatever value is
comfortable. It also allows you to disable the Beep
tone, if desired.
U-07 ( )
Function: Enabling/Disabling of the "Peak-Hold"
function of the S/PO meter.
Available Values: (off) ~
Default: (off)
U-08 ( )
Function: Adjustment of illumination level for front
panel display
Available Values: /
Default:
In low-light situations, activating the Dimmer may re-
duce excess brightness in the display. For normal
room lighting, however, this Menu Item should be set
to Off for best visibility.
when the
X
] key only causes you to
] key is
SPOT
~ Hz
ms.
73