Safety Precautions; Power Connections; Ground Connections; Electrical Shock Prevention - Yaesu FT-920 Operating Manual

1. Power Connections

Be certain to follow the guidelines on page 6 care-
fully so as to ensure that your AC power supply is
configured for the AC line voltage used in your area.
When making DC connections, be absolutely certain
to observe proper polarity in your wiring. Note that
other manufacturers may use the same type of DC
power connector as does Yaesu, but the wiring con-
figuration of the other manufacturer's plug may be
different from that specified for your transceiver. Ac-
cordingly, you should verify the pin configuration of
the plug before attempting to use a non-Yaesu DC
cable of any kind.

2. Ground Connections

Besides following the guidelines presented on page
8 carefully, note that household or industrial gas lines
must never be used in an attempt to establish an
electrical ground. Cold water pipes may, in some in-
stances, help in the grounding effort, but gas lines
represent a significant explosion hazard, and should
never be used.

3. Electrical Shock Prevention

Be certain that all station wiring is properly insulated
so as to prevent short-circuits which could damage
this transceiver and/or accessories connected to it.
Be sure to protect power cables from damage due to
abrasion by ensuring that they cannot be walked upon
nor crushed under rolling chairs, etc. Never route
power cables near sharp metallic edges which might
cut through protective insulation.
Never spill liquids into this transceiver, and do not
drop sharp metallic objects into the transceiver en-
closure. Electrical shock may result when you attempt
to remove the object.
Unsupervised children should be kept away from any
electrical apparatus such as the FT-920 transceiver
and its accessories.
FT-920 Operating Manual

4. Antenna Precautions

Always install antennas such that they can never
come in contact with outdoor power lines in the event
of a catastrophic antenna support or power line sup-
port structure failure. An adequate safety margin is
usually provided by separating power lines from the
antenna and its support structure [1.5 times the height
of the support] plus [the length of any antenna or guy
wires attached to the support] plus [the height of the
power line support pole].
Ground the antenna support structure adequately, so
as to dissipate energy absorbed during a lightning
strike. Install appropriate lightning arrestors in the
antenna lead-in and rotator cable (if used) according
to the arrestor's instructions.
In the event of an approaching electrical storm, dis-
connect all antenna lead-in, rotator control, and power
cables completely from the station, but only if the
storm is not immediately in your area. Do not al-
low disconnected cables to touch the case of your
FT-920 transceiver or accessories, as lightning can
easily jump from the cable to the circuitry of your trans-
ceiver via the case, causing irreparable damage. If a
lightning storm is in progress in your immediate area,
do not attempt to disconnect the cables, as you could
be killed instantly should lightning strike your antenna
structure or a nearby power line.
If a vertical antenna is used, be certain that humans
and/or pets or farm animals are kept away both from
the radiating element (to prevent electrical shock and
RF exposure danger) and the ground system (in the
event of an electrical storm). The buried radials of a
ground-mounted vertical antenna can carry lethal
voltages outward from the center of the antenna in
the event of a direct lightning strike.
11