Yaesu FT-920 Operating Manual page 83

U-58 ( )
Function: Set the R Carrier Point for LSB
X
Available Values:
Dafault:
Changing this value is analogous to rotating the IF
S control, allowing you to preset the frequency
HIFT
response of the receiver during LSB operation. The
effect of the adjustment can be heard if you turn the
volume up while rotating the VFO-B Tuning Dial to
adjust the setting.
U-59 ( )
Function: Set the T Carrier Point for LSB
X
Available Values:
Dafault:
This is the same function as that of Menu Item U-58,
as applied to your voice response on LSB (T
effect may be difficult to discern, however, depend-
ing on the settings of the TX Equalizer via Menu Item
U-51.
U-60 ( )
Function: Set the T Carrier Point for LSB when the
X
Speech Processor is on
Available Values:
Dafault:
This is the same function as that of Menu Item U-59,
but is applied to your voice response on LSB (T
when the Speech Processor is on. Therefore, it is
possible to set two different response characteristics
for your voice, one for "Processor-On" and one for
"Processor Off."
U-61 ( R )
Function: Set the R Carrier Point for USB
X
Available Values:
Dafault:
Changing this value is analogous to rotating the IF
S control, allowing you to preset the frequency
HIFT
response of the receiver during USB operation. The
effect of the adjustment can be heard if you turn the
volume up while rotating the VFO-B Tuning Dial to
adjust the setting.
FT-920 Operating Manual
~ kHz
~ kHz
). The
X
~ kHz
)
X
~ kHz
U-62 ( )
Function: Set the T Carrier Point for USB
X
Available Values:
Dafault:
This is the same function as that of Menu Item U-58,
as applied to your voice response on USB (T
effect may be difficult to discern, however, depend-
ing on the settings of the TX Equalizer via Menu Item
U-51.
U-63 ( )
Function: Set the T Carrier Point for USB when the
X
Speech Processor is on
Available Values:
Dafault:
This is the same function as that of Menu Item U-59,
but is applied to your voice response on USB (T
when the Speech Processor is on. Therefore, it is
possible to set two different response characteristics
for your voice, one for "Processor-On" and one for
"Processor Off."
U-64 ( )
Function: Set the "hang time" for the VOX circuitry
Available Values: ~
Default: (Corresponding to 1 second)
The above scale of 1 ~ 15 is in 0.2 second incre-
ments, allowing precise setting of the desired VOX
recovery time.
U-65 ( )
Function: Set the gain of the VOX circuitry's input
audio detector
Available Values: ~
Default:
The adjustment values are an arbitrary scale. Set the
VOX Gain to the level which quickly activates the
transmitter, yet does not pick up extraneous noises
in your operating room.
~ kHz
). The
X
~ kHz
)
X
81