Table 9: Ht-502 Advanced Configuration - Grandstream Networks HandyTone-502 User Manual

T 9: HT–502 A
ABLE DVANCED
Admin Password
Layer 3 QoS
Layer 2 QoS
STUN Server
Keep-alive interval
Firmware Upgrade
and Provisioning
Via TFTP Server
Via HTTP Server
Firmware Server Path IP address or domain name of firmware server.
Config Server Path
Firmware File Prefix
Firmware File Postfix
Config File Prefix
Config File Postfix
Automatic Upgrade
Grandstream Networks, Inc.
C P D
ONFIGURATION AGE
This contains the password to access the Advanced Web Configuration page.
This field is case sensitive.
This field defines the layer 3 QoS parameter which can be the value used for IP
Precedence or Diff-Serv or MPLS. Default value is 48.
Value used for layer 2 VLAN tag. Default setting is blank.
IP address or Domain name of the STUN server.
This parameter specifies how often the HT–502 sends a blank UDP packet to
the SIP server in order to keep the "hole" on the NAT open. Default is 20
seconds. Minimum value is 20 seconds.
Enables HT–502 to download firmware or configuration file through either the
TFTP or HTTP server.
This is the IP address of the configured TFTP server. If selected and it is non-
zero or not blank, the HT–502 retrieves the new configuration file or new code
image from the specified TFTP server at boot time. After 5 attempts, the
system will timeout and will start the boot process using the existing code
image in the Flash memory. If a TFTP server is configured and a new code
image is retrieved, the new downloaded image is saved into the Flash memory.
Note: Please do NOT interrupt the TFTP upgrade process (especially the
power supply) as this will damage the device. Depending on the network
environment this process can take up to 15 or 20 minutes.
The URL for the HTTP server used for firmware upgrade and configuration via
HTTP.
For example, ttp://provisioning.mycompany.com:6688/Grandstream/1.0.0.36
":6688" is the specific TCP port where the HTTP server is listening; it can be
omitted if using default port 80.
Note: If Auto Upgrade is set to No, HT–502 will only do HTTP download once
at boot up.
IP address or domain name of configuration server.
Default is blank. If configured, HT–502 will request firmware file with the prefix.
This setting is useful for ITSPs. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is blank. End user should keep it blank.
Default is "NO".
When set to No, HT–502 will only do upgrade once at boot up. "Check every
day ", " Check every week", "Always check for New Firmware
Check New Firmware only when F/W pre/suffix changes"
HT-502 User Manual
Firmware 1.0.0.29
EFINITIONS
at Boot up
." "
Page 19 of 31
Last Updated: 01/2007