Placing A Phone Call; Phone Or Extension Numbers; Direct Ip Calls - Grandstream Networks HandyTone-502 User Manual

10 "MAC Address"
WAN Port Web Access
12
13 Firmware Server IP
Address
14 Configuration Server IP
Address
15 Upgrade Protocol
16 Firmware Version
17 Firmware Upgrade
47 "Direct IP Calling"
99 "RESET"
"Invalid Entry"
Five Success Tips when using the Voice Prompt
1. "*" shifts down to the next menu option
2. "#" returns to the main menu
3. "9" functions as the ENTER key in many cases to confirm an option
4. All entered digit sequences have known lengths - 2 digits for menu option and 12 digits for IP
address. For IP address, add 0 before the digits if the digits are less than 3 (i.e. - 192.168.0.26
should be key in like 192168000026. No decimal is needed).
5. Key entry can not be deleted but the phone may prompt error once it is detected
P P C
LACING A HONE ALL
P E N
HONE OR XTENSION UMBERS
1. Dial the number directly and wait for 4 seconds (Default "No Key Entry Timeout"); or
2. Dial the number directly and press # (Use # as dial key" must be configured in web configuration).
Examples:
1. Dial an extension directly on the same proxy, (e.g. 1008), and then press the # or wait for 4 seconds.
2. Dial an outside number (e.g. (626) 666-7890), first enter the prefix number (usually 1+ or international
code) followed by the phone number. Press # or wait for 4 seconds. Check with your VoIP service
provider for further details on prefix numbers.
D IP C
IRECT ALLS
Direct IP calling allows two parties, that is, a FXS Port with an analog phone and another VoIP Device, to
talk to each other in an ad hoc fashion without a SIP proxy.
Grandstream Networks, Inc.
Announces the Mac address of the unit.
Press "9" to toggle between enable / disable
Announces current Firmware Server IP address. Enter 12
digit new IP address.
Announces current Config Server Path IP address. Enter
12 digit new IP address.
Upgrade protocol for firmware and configuration update.
Press "9" to toggle between TFTP / HTTP
Firmware version information.
Firmware upgrade mode. Press "9" to toggle among the
following three options:
- always check
- check when pre/suffix changes
- never upgrade
Enter a 12 digit IP address to make a direct IP call, after
dial tone. (See "Make a Direct IP Call".)
Press "9" to reboot the device. See p. 27 for factory reset.
Automatically returns to main menu
HT-502 User Manual
Firmware 1.0.0.29
Page 10 of 31
Last Updated: 01/2007