Configuration Guide; Configuring Ht-502 Through Voice Prompt - Grandstream Networks HandyTone-502 User Manual

C
ONFIGURATION
C HT–502
ONFIGURING
DHCP M : Select voice menu option 01 to enable HT–502 to use DHCP.
ODE
STATIC IP M : Select voice menu option 01 to enable HT–502 to use STATIC IP mode, then use
ODE
option 02, 03, 04, 05 to set up IP address, Subnet Mask, Gateway and DNS server respectively.
F S IP A
IRMWARE ERVER DDRESS
server.
C S
ONFIGURATION ERVER
configuration server.
U P : Select voice menu option 15 to choose firmware and configuration upgrade
PGRADE ROTOCOL
protocol. User can choose between TFTP and HTTP.
F U M
IRMWARE PGRADE ODE
following three options: 1) always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN P W A
ORT EB CCESS
configuration pages.
Grandstream Networks, Inc.
G
UIDE
V P
THROUGH OICE ROMPT
: Select voice menu option 13 to configure the IP address of the firmware
IP A : Select voice menu option 14 to configure the IP address of the
DDRESS
: Select voice menu option 17 to choose firmware upgrade mode among the
: Select voice menu option 12 to enable WAN Port Wed Access of the device
HT-502 User Manual
Firmware 1.0.0.29
Page 14 of 31
Last Updated: 01/2007