(2) Method of editing cycle data
1) Set the mode to input mode.
Under the input mode where SET READY LED
goes out, entry of the cycle data is enabled.
If the current mode is the sewing mode, press
READY key ❷
to the input mode.
2) Set cycle data to editing status.
When EDIT key ❽
data editing display C appears on the screen. The
pattern No. D to be sewn is displayed in reverse
video.
In this state, it is possible to edit the data.
3) Select editing point.
When you press ITEM SELECT key ❻
ly-selected edit point is displayed in reverse video. When the edit point is carried to the last piece of data,
the additional indication pictograph is displayed if there is an available pattern number. If you bring the
edit point forward further, the data name will be the edit point.
When you press the edit key while the edit point is being selected, the edit point data can be changed.
In the case the edit point is the pattern number
The additional indication pictograph is displayed at the selected position to enable insertion of pattern
data.
In the case tIn the case the edit point is the data name
The data name can be edited.
The selection sequence of edit points when the item select key is pressed
Pattern name
to change over the mode
is pressed, the cycle
, the edit point will be changed in sequence and the current-
Pattern number
– 47 –
D
❷
❸
Pattern number to be
added to the last piece of
data (can only be selected
in the case an available
pattern number that can
be input is left)
❽
❻
❼
❾
C