JUKI LBH-1790A Series Instruction Manual page 37

No.
Compensation of bar-tacking width, right
S010
This item adjusts right side outer shape of bar-tack-
ing section in terms of overedging section. It is cor-
rected 1st and 2nd bar-tacking together.
Top of Bottom
square of square
type type
Compensation of bar-tacking width, left
S011
This item adjusts left side outer shape of bar-tacking
section in terms of overedging section.
Top of Bottom
square of square
type type
S012 Taper bar-tacking offset, left
This item sets length to form bar-tacking section of
taper bar-tacking shape.
S013 Taper bar-tacking offset, right
This item sets length to form bar-tacking section of
taper bar-tacking shape.
S014 Eyelet shape length
This item sets upper side length from center of eye-
let of eyelet shape.
Number of stitches of eyelet shape
S015
This item sets number of stitches in the upper 90˚ of
eyelet shape.
Eyelet width
S016
This item sets crossuise size of the inside of eyelet
shape. Actual needle entry point is the dimension to
which S004 Knife groove width, left is added.
S017 Eyelet length
This item sets lengthwise size of the inside of eyelet
shape.
S018 Round type shape length
This item sets upper length from the center of round
type shape.
Top of Top of
round Radial
type
type
Bottom Bottom
of round of radial
type type
Number of stitches of radial shape
S019
This item sets number of stitches in the upper 90˚ of
radial shape.
S020 Reinforcement of radial shape
This item sets with/without reinforcement stitching of radial
shape.
*1 : Displayed according to the shape
*2 : Displayed when it is set to with edit. Refer to "V-12. Method of setting sewing data with/without edit" p.32.
*3 : Displayed when the function is selected.
Item
Bottom of
straight
bar-tacking
Bottom of
straight
bar-tacking
Top of
semilunar
type
Bottom of
semilunar
type
: With : Without
Setting range
-1.00 to 1.00
-1.00 to 1.00
0.00 to 3.00
0.00 to 3.00
1.0 to 10.0
1 to 8
1.0 to 10.0
1.0 to 10.0
1.0 to 5.0
1 to 8
–
– 34 –
Edit unit Remarks
0.05 mm –
0.05 mm –
0.05 mm *1
0.05 mm *1
0.1 mm *1
*1
1
0.1 mm *1
0.1 mm *1
0.1 mm *1
*1
1
– *1, *2