Operation; Your First Fire; Pilot And Burner Inspection; Uvs27R/Honeywell Control Valve Off - Vermont Castings UVS27R Owner's Manual

Your First Fire

Read these instructions carefully and familiarize
yourself with the burner controls of this heater.
The UVS27R uses a Honeywell control valve that
allows thermostatic, on/off switch regulation and has a
separate Piezo ignition button. Figures 19-21 illustrate
the operating positions for the Honeywell valve.
The UVS27M is equipped with an SIT control valve for
manual use only. Figures 22-24 illustrate the operating
positions for the manual valve.
Locate the Pilot assembly to the right behind the
burner. (Fig. 25) Follow the lighting instructions on page
15 exactly.
During the first fire, it is not unusual to smell some odor
associated with new logs, paint and metal being
heated. Odors should dissipate within a few hours or
so, however, you can open a window to provide plenty
of fresh air to alleviate this condition.

Pilot and Burner Inspection

Each time you light your heater, check that the pilot
flame and burner flame pattern are as shown in Figures
26 and 27. If flame patterns are incorrect, turn the
heater off. See Troubleshooting , page 17.
Do not operate the heater until the pilot flame is correct.
Follow regular maintenance procedures as described
on page 16.
OFF
Fig. 19 UVS27R/Honeywell Control Valve OFF.

Operation

Fig. 20 UVS27R/Honeywell Control Valve in Pilot position.
Fig. 21 UVS27R/Honeywell Control Valve in ON position.
Use this position for remote switch operation.
Fig. 22 UVS27M/SIT Control Valve OFF.
HV101b
Fig. 23 UVS27M/ SIT Control Valve in Pilot position.
Fig. 24 UVS27M/SIT Control Valve in ON position.
Vermont Castings UVS27
OFF
OFF
Piezo Ignitor
PILOT
Piezo
Ignitor
ST107
13
m