Connecting To A Power Source; Figure 3-5. Power Receptacle - SMC Networks TigerStack II 10/100 User Manual

I S
NSTALLING THE

Connecting to a Power Source

Note: It is recommended that the hubs be stacked before being
connected to a power source. However, a device can be
added to the top or bottom of a stack that is on and operat-
ing without first powering down the stack. Be sure to stack
the new device before connecting it to a power source.
To connect each device to a power source:
1. Insert the power cable plug directly into the receptacle located
at the back of the device.

Figure 3-5. Power Receptacle

2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line
cord. You must use a line cord set that has been approved
for the receptacle type in your country.
3. Check the front-panel LEDs as each device is powered on.
On the hub, the following LEDs should light:
Power LED—green
K
Switch LED (if a Switch Module is installed)—green
K
On one Network Management Module, the following LED
should light:
Master LED—green
K
3-8
TACK