Wiring Closet Connections - SMC Networks TigerStack II 10/100 User Manual

M N
AKING ETWORK
2. If the device is a network card and the TigerStack II 10/100 is
in the wiring closet, attach the other end of the cable segment
to a modular wall outlet that is connected to the wiring closet
(see "Wiring Closet Connections" on the next page). Otherwise,
attach the other end to an available port on the hub.
3. If the device is a hub or switch, attach the other end to the
appropriate port on the hub (port 12 or 24).

Wiring Closet Connections

Today, the punch-down block is an integral part of many of the
newer equipment racks. It is actually part of the patch panel.
Instructions for making connections in the wiring closet with this
type of equipment follows.
1. Attach one end of a patch cable to an available port on the
hub, and the other end to the patch panel.
2. If not already in place, attach one end of a cable segment to
the back of the patch panel where the punch-down block is
located, and the other end to a modular wall outlet.
3. Label the cables to simplify future troubleshooting.
4-4
C
ONNECTIONS