Connecting To A Power Source - SMC Networks 6924MT - annexe 1 Installation Manual

Connecting to a Power Source

To connect a device to a power source:
Note: It is recommended that the switches be stacked before being
connected to a power source. However, a device can be added to
the top or bottom of a stack that is on and operating without first
powering down the stack. Be sure to stack the new device before
connecting it to a power source. All switches in a stack must be
powered on to allow traffic to pass across the stack's backplane.
To connect each device to a power source:
1. Insert the power cable plug directly into the receptacle located at the
back of the device.
Figure 3-6. Power Receptacle
2. Plug the other end of the cable into a grounded, 3-pin socket.
Note: For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the
receptacle type in your country.
I
NSTALLING THE
S
WITCH
3-9