Data Cloning - Icom IC-R6 Instruction Manual

10
OTHER FUNCTIONS

■ Data cloning

Cloning allows you to quickly and easily transfer the pro-
grammed contents from one receiver to another; or data from
a personal computer to a receiver, using the optional CS-R6
and the appropriate cloning cable.
cloning software
DCloning between receivers
q Connect the OPC-474 cloning cable to the [SP] jack of the
master and sub-receivers.
• The master receiver is used to send data to the sub-receiver.
to [SP]
Master
receiver
NOTE: DO NOT push any key on the sub-receiver during
cloning. This will cause a cloning error.
61
to [SP]
Sub
receiver
w Hold down [V/M] of only the master receiver, and then
turn it ON. For the sub-receiver, simply turn it ON. (See
below for more information.)
Master receiver
✔ CLONING MODE ENTRY (except Master receiver):
When the CI-V baud rate (p. 56) is selected any other than
"9600" or "AUTO," the following operations are required.
q Turn the receiver's power OFF.
w While holding down [MODE], push and hold [ ] for 1 sec-
ond to enter the cloning mode.
"CLONE" and "m" appear
when entered the cloning
mode.