Icom IC-R6 Instruction Manual page 49

D Storing the skip frequencies during a VFO scan
During a VFO scan, the skip frequencies can be stored into
the highest blank memory channel which is automatically
selected with the following operation.
q Start a VFO scan.
➥ Push [V/M] to select the VFO mode.
➥ Set the squelch level.
➥ Hold down [SCAN](MODE) for 1 second to enter the
scan type selection mode.
➥ Rotate [DIAL] to select a desired scanning type.
• Select "ALL" for full scan, "BAND" for band scan, "P-LINK
x" for programmed link scan (x= 0 to 9), "PROGxx" for pro-
grammed scan (xx= 0 to 24; only programmed scan edge
numbers are displayed).
➥ Push [SCAN](MODE) to start the scan.
w When the scan pauses and you want to set the paused
frequency as a skip frequency.
➥ Hold down [FUNC], then push and hold [S.MW](V/M)
for 1 second to store the paused frequency into the
highest blank memory channel.
• While holding down [FUNC], the scan pauses; and after
writing the frequency, the scan resumes.
SCAN OPERATION
6
6
36