Vibrator Module - HP Pavilion 11 x2 PC Maintenance And Service Manual

Vibrator module

Description
Vibrator module (includes cable)
Before removing the vibrator module, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2. Disconnect the power from the tablet by unplugging the power cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the display enclosure (see
5. Disconnect the tablet battery cable from the system board (see
Remove the vibrator module:
1. Disconnect the vibrator module cable (1) from the system board.
2. Release the vibrator module cable from the routing clips (2) built into the display panel
assembly.
3. Release the vibrator module (3) from the mold built into the display panel assembly.
4. Remove the vibrator module and cable.
Reverse this procedure to install the vibrator module.
42 Chapter 5 Removal and replacement procedures
Display enclosure on page
Spare part number
741723-001
31).
Sensor board on page 32).