Important Note - Da-Lite TENSIONED COSMOPOLITAN ELECTROL Instruction Book

TENSIONED COSMOPOLITAN
120V WIRING DIAGRAM WITH
OPTIONAL BUILT-IN VIDEO
PROJECTOR INTERFACE
CAUTION: THE PROJECTOR MUST BE TURNED OFF BEFORE CONNECTING THE TRIGGER
WIRES TO THE PROJECTOR. FAILURE TO DO SO MAY DAMAGE THE CONTROLLER.
Use 2-conductor 20-24 gauge wire to extend the low voltage connection from
the projector's 5 or 12-volt screen trigger output to the length required to reach
the VPI. When extending the low voltage connection from the projector's screen
trigger output polarity does not matter. The red and black wires from the VPI are
interchangeable.

IMPORTANT NOTE:

The wall switch is REQUIRED to make any limit switch adjustments,
EVEN if a third party control system is used. Therefore, it is advised to
wire the switch or provide a 3-conductor connection that is accessible.
120V WIRING DIAGRAM
WITH OPTIONAL BUILT-IN
LOW VOLTAGE CONTROL
LED
UP LIMIT
TACTILE BUTTON
U P
S T O
P
DOWN LIMIT
D O W
N TACTILE BUTTON
BACK OF
WALL SWITCH
FRONT OF
WALL SWITCH
IMPORTANT NOTE:
The wall switch is REQUIRED to make any limit switch
adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or
provide a 3-conductor connection that is accessible.
ELECTROL INSTALLATION
® ®
U P
S T O
P
D O W
N
FRONT OF
WALL SWITCH
RJ-22
INPUTS
RJ-22
JACK
RJ-45
RECEPTACLE
POWER WIRE
LED
RJ-22
UP LIMIT
INPUTS
TACTILE
BUTTON
RJ-22
JACK
DOWN
LIMIT
TACTILE
BUTTON
BACK OF
WALL SWITCH
BLACK
RED
VPI TRIGGER
MODULE
5/12 VOLT SCREEN
TRIGGER ON PROJECTOR
WHITE (COMMON)
RJ-14 PIN-OUTS
(TAB IS FACING UP)
BUS (RP DATA) WHITE
RQ DATA GREEN
+5V RED
GND BLACK
RJ-22
JACK
Supplied RJ-14 cable
RJ-22
OUTPUT
DRY CONTACTS
RJ-45 JACK
BLACK (HOT)
WHITE (COMMON)
POWER INPUT 120VAC / 60HZ
3
RJ-22 JACK
RJ-22 OUTPUT
DRY CONTACTS
RJ-45
JACK
DATA
CABLE
RJ-45
RECEPTACLE
POWER
WIRE
GREEN (GROUND)
BLACK (HOT)
GROUND–MUST BE CONNECTED
TO BUILDING GROUND
POWER INPUT 120VAC / 60HZ
FIGURE 4
RJ-22 PIN-OUTS
(TAB IS FACING UP)
+12V
BUS (RP DATA)
RQ DATA
+5V
GND
RQ CLOCK
Standard RJ-22 can be used in place of RJ-14
RJ-45 PIN-OUTS
(TAB IS FACING UP)
MANUAL 2
+12V
BUS (RP DATA)
RQ DATA
+5V
GND
RQ CLOCK
DATA MANUAL 1
CABLE
GREEN (GROUND)
GROUND–MUST BE
CONNECTED TO
FIGURE 5
BUILDING GROUND
BLUE
YELLOW
GREEN
RED
BLACK
WHITE
BROWN
BLUE
YELLOW
GREEN
RED
BLACK
ORANGE
PURPLE