1. Manuals
  2. Brands
  3. Da-Lite Manuals
  4. Projection Screen
  5. TENSIONED COSMOPOLITAN ELECTROL
  6. Instruction book

Da-Lite TENSIONED COSMOPOLITAN ELECTROL Instruction Book

For sizes up to 10'x10'
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
The Da-Lite Difference.
Instruction Book for
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
TensIoned CosmopolITan® eleCTrol®
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: 574-267-8101
For sizes Up To 10'x10'
800-622-3737
Fax: 574-267-7804
Toll Free Fax: 877-325-4832
www.da-lite.com
e-mail: info@da-lite.com

Advertisement

Table of Contents
loading

Related Manuals for Da-Lite TENSIONED COSMOPOLITAN ELECTROL

Summary of Contents for Da-Lite TENSIONED COSMOPOLITAN ELECTROL

  • Page 1 The Da-Lite Difference. Instruction Book for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street TensIoned CosmopolITan® eleCTrol® Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 For sizes Up To 10'x10' 800-622-3737 Fax: 574-267-7804 Toll Free Fax: 877-325-4832 www.da-lite.com e-mail: info@da-lite.com...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2. Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3.
  • Page 3 Contact the factory for further information. 240 VOLT WIRING DIAGRAM FOR STANDARD WALL SWITCH: Da-Lite offers two styles of 240 volt wall switches for standard operation. Please see wiring diagram included in wall switch box included with screen.

  • Page 4: Important Note

    TENSIONED COSMOPOLITAN ELECTROL INSTALLATION ® ® RJ-22 JACK 120V WIRING DIAGRAM WITH RJ-22 OUTPUT RJ-22 OPTIONAL BUILT-IN VIDEO UP LIMIT INPUTS DRY CONTACTS TACTILE PROJECTOR INTERFACE BUTTON RJ-22 JACK S T O RJ-45 CAUTION: THE PROJECTOR MUST BE TURNED OFF BEFORE CONNECTING THE TRIGGER DOWN JACK DATA...

  • Page 5: Low Voltage Control

    The screen surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. The screen should not be adjusted for more or less drop. The fabric cables are adjusted for proper vertical and lateral tension at Da-Lite.

  • Page 6: Stop Button

    SCREEN ADJUSTMENT FOR 120V SCREENS WITH A BUILT-IN LOW VOLTAGE CONTROL OR VPI 1. Locate the wall switch and remove the cover plate from the 3-button wall switch and remove the switch from the junction box. 2. Locate the two tactile buttons on the back of the switch. They are square silver with black round buttons. See Figure 4 (VPI) or Figure 5 (LVC) for diagram.

  • Page 7: Troubleshooting

    TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. Screen will not operate. (a) Incorrect line voltage. (a) Verify 115-125V (or 220-240V). If insufficient voltage, rewire Motor does not hum. incoming electric line. (b) Blown fuse. (b) Replace fuse. (c) Tripped circuit breaker. (c) Reset circuit breaker. (d) No power to operating switch (d) Check above.
  • Page 8 EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137 , Warsaw, IN 46581-0137 , (574) 267-8101, (800) 622-3737 .

This manual is also suitable for:

Tensioned cosmopolitan electro

Table of Contents