Advertisement
Quick Links
The Da-Lite Difference.
Instruction Book for
DA-LITE SCREEN COMPANY, INC.
3100 North Detroit Street
tensIoned professIonal electrol®
Post Office Box 137
Warsaw, Indiana 46581-0137
Phone: 574-267-8101
800-622-3737
Fax: 574-267-7804
www.da-lite.com
e-mail: info@da-lite.com
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Da-Lite TENSIONED PROFESSIONAL ELECTROL
Summary of Contents for Da-Lite TENSIONED PROFESSIONAL ELECTROL
- Page 1 The Da-Lite Difference. Instruction Book for DA-LITE SCREEN COMPANY, INC. 3100 North Detroit Street tensIoned professIonal electrol® Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574-267-8101 800-622-3737 Fax: 574-267-7804 www.da-lite.com e-mail: info@da-lite.com...
-
Page 2: Pre-Installation
PRE-INSTALLATION 1. Carefully unpack screen. 2. Make sure to recheck measurements of screen location before installation. 3. Remove instruction cover plate (Fig. 1). Do not remove wrapping paper until screen is installed. 4. Remove the retainer screws from the slat bar before the case has been installed (Fig. 2). (3 SCREWS) 1 ON BOTTOM OF SLAT 2 ON INSIDE OF CASE... -
Page 3: Screen Adjustment
Surface travel is stopped automatically in the fully opened and closed positions by limit switches that are properly adjusted at Da-Lite. Should it be necessary to adjust more or less drop of picture, proceed in the following manner: CAUTION! WHEN ADJUSTING AND TESTING, BE PREPARED TO STOP SCREEN QUICKLY AS SERIOUS DAMAGE MAY OCCUR. - Page 4 TENSIONED PROFESSIONAL ELECTROL INSTALLATION ® 9-1/2" 11-5/16" Reinforced Motor End Electrical Outlet Box SUGGESTED METHODS OF INSTALLATION CEILING TYPE HANGER RAFTERS 2" MOULDING PICTURE SURFACE PICTURE SURFACE 1" x 3" CLEAT RECESSED ABOVE CEILING PICTURE Other methods of installation SURFACE...
- Page 5 NOTE: A SINGLE SWITCH CANNOT BE USED TO OPERATE MORE THAN ONE SCREEN. CONTACT THE FACTORY FOR FURTHER INFORMATION. 240 VOLT WIRING DIAGRAM FOR STANDARD WALL SWITCH: Da-Lite offers two styles of 240 volt wall switches for standard operation. Please see wiring diagram in wall switch box included with screen.
- Page 6 TROUBLESHOOTING SYMPTOM CAUSE SOLUTION 1. Screen will not operate. (a) Blown fuse. (a) Replace fuse. Motor does not hum. (b) Tripped circuit breaker. (b) Reset circuit breaker. (c) No power to operating switch (c) Check above. Tighten all loose or junction. wire connections.
- Page 8 EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR CONSEQUENTIAL DAMAGES OF ANY NATURE. In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales Partners at PO Box 137 , Warsaw, IN 46581-0137 , (574) 267-8101, (800) 622-3737 .
Need help?
Do you have a question about the TENSIONED PROFESSIONAL ELECTROL and is the answer not in the manual?
Questions and answers