Set Modulation; Set Attenuator; Set Priority; Set Alert - Uniden UBCD396XT Owner's Manual

Set Modulation

Select what type of modulation the scanner should use for this frequency or
channel.
The scanner uses the default modulation type for this frequency's band.
Auto
The scanner treats the frequency as an AM band.
AM
The scanner treats the frequency as a Narrowband FM band.
NFM
The scanner treats the frequency as an FM band.
FM
The scanner treats the frequency as a Wideband FM band.
WFM
The scanner treats the frequency as an FM broadcast band.
FMB

Set Attenuator

Turn on attenuation to reduce the signal strength by 20 dB. You can turn on
attenuation for individual frequencies and channels or for entire sites. If you turn
on attenuation for a site, all frequencies within that site will be attenuated.

Set Priority

Choose whether this channel should be flagged as a priority channel so the scanner
checks it during priority scans and searches.

Set Alert

This menu lets you configure whether the scanner triggers an alert tone and light
whenever this channel or frequency becomes active. (Compare this to the system
setting Emergency
contains an emergency flag.) The available options for
Alert Light are common to both types of alerts.

Set Lockout

Decide whether you want to lock out the channel so the scanner will ignore it
during Scan and Search modes. Choose one of the following options:
 Unlocked: The channel is not locked out.
 Temporary L/O: The channel is locked out until you turn the scanner off and
back on.
 Lockout: The channel is permanently locked out.
Alert, which triggers a tone and light when a Talk Group
UBCD396XT
Set Alert Tone
117
and Set