Set Attenuator; Using Fire Tone-Out; Setting Up Tone-Out - Uniden BCD396T Manual

Easier to Read BCD396T/UBCD396T Digital Scanner Manual
SS: The state code.
CCC: The county code.
Scroll to 'Program SAME' and press E/yes.
At 'Select SAME' scroll to the SAME group (1-5) and press E/yes.
At 'Edit Name' see
Entering Text
At 'Select Code No' scroll to the spot for the code# (1-8) and press E/yes.
At 'Edit FIPS Code' enter the FIPS code and press E/yes to save and exit.
Scroll to the next spot for the next code and repeat
Press Menu twice to return and select a different SAME group.
Press Menu to save and exit.
Set Delay Time
Sets the number of seconds the scanner should wait after a transmission stops before moving on to the next channel during weather scan. The default
setting is 2 seconds.
Scroll to 'Set Delay Time' and press E/yes.
Scroll to 1, 2, 3, 4, 5, (seconds) or Off and press E/yes to save and exit.

Set Attenuator

Sets the attenuator (18 dB) for weather operation. The default setting is off.
Scroll to 'Set Attenuator' and press E/yes.
Scroll to On or Off and press E/yes to save and exit.
Weather Alert
This setting turns on weather alert and determines which types of signals will trigger an alert. The scanner will mute and scan only the weather channels.
Warning! If you receive an alert it will be at FULL volume.
Scroll to 'Weather Alert' and press E/yes. Scroll to 1 of 7 options and press E/yes.
Alert Only - the scanner immediately sounds a weather alert siren when it detects the 1050 Hz weather alert tone, then opens the squelch and remains on the weather
channel.
SAME group 1-5 - the scanner sounds a weather alert siren for the programmed county, then opens the squelch and remains on the weather channel.
All FIPS - the scanner sounds a weather alert siren for any programmed county, then opens the squelch and remains on the weather channel.
With the tone out feature, the scanner monitors up to 10 different channels for paging tones (two-tone sequential, single tone, and group tone).
See also Hardware: Tone-out at WPA

Setting up Tone-Out

Press Menu. Scroll to 'Tone-Out for...' and press E/yes.
Scroll to 'Tone-Out Setup' and press E/yes.
1' and press E/yes.
Scroll to 'Tone-Out
At 'Edit Name' press E/yes. See
Frequency' press E/yes.
Scroll to 'Set
At 'Edit Frequency' press E/yes. Enter the frequency to monitor for tone-out and press E/yes to save and exit.
Scroll to 'Set Modulation' and press E/yes. Scroll to Auto, FM, or NFM and press E/yes to save and exit.
Scroll to 'Set Attenuator' and press E/yes. Scroll to On or Off and press E/yes to save and exit.
Press Menu to return.
http://marksscanners.com/396/396.shtml (41 of 51)8/17/2010 10:11:40 PM
to edit the name otherwise scroll to 'Edit County' and press E/yes.

Using Fire Tone-Out

Scanner.
Entering Text.
Contents
Contents