Set Locationinfo; Set Latitude And Set Longitude; Set Range; Set Gps Enable - Uniden UBCD396XT Owner's Manual

UBCD396XT

33. Set LocationInfo

Use this menu to configure geographic information for each system or site. With
this information and a standard NMEA GPS input, the scanner can automatically
change which systems, sites and channel groups it scans as you change location.
You must set the location information if you want to use Location-based Scanning.

Set Latitude and Set Longitude

Enter the latitude and longitude of the center of this system or site. You can use
any geographical coordinates as the center, but most often it will be the physical
location of the antenna, the center of a city, county, or other geopolitical territory,
or some combination of the two.
Geographical coordinates can be represented in a few different ways. The two most
common representations are DMS and Deg.
DMS breaks the coordinate into Degrees, Minutes, and Seconds. This is typically
represented like: 44° 58' 12.79" N. Your scanner uses this format.
Decimal degrees simply use the degrees expressed as a decimal number. 44° 59'
12" equates to 44.97381 Degrees. Mathematically, you can change DMS to Deg
using the formula DDD + MM/60 + SS.ss/3600. You would perform the reverse
calculation to convert Deg to DMS.
To more easily convert Decimal Degrees to the DDD° MM' SS.sss" format or vice
versa, see the converter at this url;
http://transition.fcc.gov/mb/audio/bickel/DDDMMSS-decimal.html

Set Range

Enter the maximum distance from the center that this site or channel will be active.
As long as your position is within the radius you enter here, the scanner monitors
this site or channel; when you leave the channel range, the scanner locks out this
site or channel.
The scanner treats the number you enter here as miles or kilometers depending on
the value you selected in the Set Unit field in the Set GPS Format menu (under the
main Settings menu). Enter a range from 0.5 through 125.0 mi/km, in 0.5 mi/km
steps.

Set GPS Enable

114