FULTON 60E Operator, Service & Parts Manual page 4

The instructions provided for the operation and maintenance of the boiler MUST be observed.
Failure to do so could result in damage to the boiler and serious personal injury.
WARNING
It is the responsibility of the installer to ensure all
parts supplied with the boiler are fitted in a correct and
safe manner.
WARNING
Do not try to do repairs or any other maintenance
work you do not understand. Obtain a Service Manual
from Fulton or call a Fulton Service Engineer
WARNING
Understand the electrical circuit before connecting or
disconnecting an electrical component. A wrong
connection can cause injury and or damage.
WARNING
A defective boiler can injure you or others. Do not
operate a boiler which is defective or has missing
parts. Make sure that all maintenance procedures are
completed before using the boiler.
CAUTION
Obey all laws and local regulations which affect you
and your boiler.
WARNING
The installation of Gas appliances including the flue
system should only be carried out by Corgi Regis-
tered engineers.
CAUTION
HYDRAULIC TEST - RISK OF BRITTLE FRACTURE
Hydraulic testing requires specialist equipment and
is normally only required by engineering surveyors /
inspectors.The material the boiler is manufactured
from, has not been impact tested, as it is not a
requirement of BS2790 (boiler construction stand-
ard). In order to ensure the material / pressure vessel
does not suffer from brittle fracture, hydraulic testing
should not be carried out below 5
WARNING
The importance of correct boiler water and feed water
cannot be over emphasised, see the relevant section
in this manual.
CAUTION
LOW FEED WATER TEMPERATURE
Low feed water temperature can result in thermal
shock to the boiler pressure vessel. Return the maxi-
mum amount of condensate and if necessary pre-
heat the feed water. If in doubt consult FBW.
SAFETY
Only qualified persons should be allowed to
operate and maintain the boiler and its equip-
ment. Boilers should always be drained through an
approved Blowdown Vessel.
Non-approved modifications can cause injury and
damage. Contact your Fulton dealer before modifying
the boiler.
O
C.
GFSE-Std-0499
WARNING
WARNING
Do not change the boiler fuel without consulting the
boiler manufacturer.
WARNING
WARNING
You can be injured if you use faulty lifting equipment.
Make sure the lifting equipment is in good condition.
Make sure that lifting tackle complies with all local
regulations and is suitable for the job
WARNING
Operating the boiler beyond its design limits can
damage the boiler, it can also be dangerous. Do not
operate the boiler outside its limits. Do not try to up
grade the boiler performance by unapproved modifica-
tions.
WARNING
DANGER FROM HOT SURFACES
Steam Boilers have high temperature surfaces, that if
touched may cause serious burns. Only competant
and qualified personnel should work on or in the
locality of a steam boiler and ancillary equipment.
Always ensure the working area and floor are clear of
potential hazards, work slowly and methodically.
WARNING
DANGER FROM INCOMPLETE COMBUSTION
The importance of correct burner adjustment to achive
low emissions, safe, clean and efficient combustion
is paramount. Poor combustion, where unburnt gas
forms carbon monoxide is both a health hazard, and
the potential risk to the boiler from overheating,
caused by re-burning of the unburnt gas in the
secondary flue passes.