Warnings And Safety Instructions - Kodak 2200 User Manual

Warnings and Safety Instructions

1-2
•
To ensure safety, read all user manuals carefully before using the
system and observe all Caution, Important, and Note callouts located
throughout the manual.
•
Keep this manual with the equipment.
•
Reading this manual does not qualify you to operate, test, or
calibrate this system.
•
Unauthorized personnel are not allowed access to the system.
•
If the product does not operate properly or fails to respond to the
controls as described in this manual:
•
Follow the safety precautions as specified in this manual.
•
Stop using the equipment and do not make or authorize any changes
to it.
•
Immediately contact your Service Representative, report the
problem, and await further instructions.
•
X-ray systems manufactured by Carestream Health, Inc. comply with
safety standards throughout the world for optimum protection against
radiation risks.
•
Be aware of the product specifications and of system accuracy and
stability limitations. Consider these limitations before making any decision
based on quantitative values. If you have any doubts, consult your Sales
Representative.
CAUTION:
X-rays can be dangerous if used incorrectly. Take precautions even
when following the instructions in this manual.
Use conventional commercially available equipment to protect yourself
and your patients against scattered radiation risks.
•
If you fail to comply with these instructions, Carestream Health, Inc.
will not be responsible for the safety reliability, and characteristics of the
equipment.
CAUTION:
Do not operate the equipment in the presence of explosive liquids,
vapors, or gases. Do not plug in or turn on the system if hazardous
substances are detected in the environment. If these substances are
detected after the system has been turned on, do not attempt to turn off
the unit or unplug it. Evacuate and ventilate the area before turning off
the system.
DANGER: THIS IS AN ELECTRICAL UNIT. DO NOT EXPOSE IT TO
WATER SPRAY. SUCH ACTION MAY CAUSE AN
ELECTRICAL SHOCK OR A MALFUNCTION OF THE UNIT.
SM731_K2200_01_en 06/2009