What To Do If - Electrolux E5745-5 User Manual

40

What to do if ...

What to do if ...
Problem
The cooking zones are not
functioning
The oven is not heating up
The oven lighting is not
working
F2 appears in the time display Door not closed properly or door
A fault code that is not listed
above appears in the clock
display
If you are unable to remedy the problem by following the above suggestions,
please contact your local Service Force Centre.
Warning! Repairs to the appliance are only to be carried out by qualified service engi-
neers. Considerable danger to the user may result from improper repairs.
If the appliance has been operated incorrectly, the engineer's visit will be chargeable,
even during the warranty period.
Advice on cookers with metal fronts:
Because of the cold surface at the front of the cooker, opening the oven door during (or
just after) baking or roasting may cause the glass to steam up.
Possible cause
Refer to the operating instructions for the built-in cooking sur-
face
The oven is not switched on
The time is not set
The required settings have not
been set
The oven's automatic cut out has
been triggered.
The fuse in the house's electrical
wiring (fuse box) has been trig-
gered
The oven light is broken
lock faulty
Electronic fault
Remedy
Switch on the oven
Set the current time on the
clock
Check the settings
See automatic cut out.
Check fuse If the fuses trigger
several times, please call a
qualified electrician.
Replace oven light bulb
Close door properly;
Switch the appliance off and
on again using the house
fuse or the safety switch in
the fuse box;
If it is displayed again, please
contact the Customer Service
Department
Switch the appliance off and
on again using the house
fuse or the safety switch in
the fuse box.
If it is displayed again, please
contact the Customer Service
Department