What To Do If - Electrolux EOBP8801VX Manual

13. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
Problem
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The appliance does
not heat up.
The display shows
F111.
The lamp does not
operate.
A
45°
Possible cause
The appliance is deactiva-
ted.
The clock is not set.
The necessary settings are
not set.
The Child Lock is activated.
The fuse is released.
The CT Sensor plug is not
correctly installed into the
socket.
The lamp is defective.
A
Removing the door
1.
Open the door as far as it goes.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the door until it is at an angle
of approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the appli-
ance at an upwards angle.
Installing the door
To install the door do the above steps in
the opposite sequence.
CAUTION!
Be careful when you remove the
door from the appliance. The door
is heavy. There is a risk of injury or
damage to the appliance.
Put the door with the outer side
down on a soft and level surface
to prevent scratches.
Remedy
Activate the appliance.
Set the clock.
Check the settings.
Refer to "Activating and de-
activating the Child Lock
function".
Make sure that the fuse is
the cause of the malfunc-
tion. If the fuse releases
again and again, contact a
qualified electrician.
Put the plug of core temper-
ature sensor as far as possi-
ble into the socket.
Replace the lamp.
ENGLISH 47