MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 30

Setup 4-Up Display
1. From the single or four engine parameter display touch
the "Menu Button
0 1500 3000
1800 RPM
ENG RPM
COOL TEMP
2. The main menu will pop up on the display. Use the
"Arrow Buttons" to scroll through the menu until the
"Setup 4-Up Display" is highlighted.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
3. Once the "Setup 4-Up Display" menu item has been
highlighted touch the "Enter Button" to activate the
"Setup 4- Up Display" menu.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
4. Touch the "Enter Button" to activate the "Use Defaults"
function. This action will reset the unit to the factory
default.
USE DEFAULTS
CUSTOM SETUP
AUTOMATIC SCAN OFF
PAGE 30 — DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11)
1000 RPM
98%
ENG RPM
LOAD RPM
14.2 57 PSI
BATT VOLT OIL PRES
DIAGNOSTIC DISPLAY
5. The "Use Defaults" screen will be displayed during the
resetting period then will automatically return to the
"Setup 4- Up Display" menu.
6. Select the "4-Up Custom Setup" from the "4-Up Setup"
menu.
USE DEFAULTS
CUSTOM SETUP
7. The quadrant with the backlit parameter value is the
current selected parameter. Use the "Arrow Buttons"
to highlight the parameter value in the quadrant you
wish to place a new parameter.
USE DEFAULTS
CUSTOM SETUP
8. Touch the "Enter Button" and a list of parameters will
appear.
125°F
COOL TEMP
14.2
BATT VOLT
RESTORED TO
DEFAULTS
1000 RPM
ENG RPM
57 PSI
OIL PRES