MULTIQUIP Power DCA85USJ2 Operation And Parts Manual page 23

2. The main menu will pop up on the display. Use the
"Arrow Buttons" to scroll through the menu until the
"Engine Confi guration" menu item has been highlighted
.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
3. Once the "Engine Confi guration" menu item has been
highlighted touch the "Enter Button" to view the engine
confi guration data.
GO TO 1-UP DISPLAY
STORED CODES
ENGINE CONFG
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
4. Use the "Arrow Buttons" to scroll through the engine
confi guration data.
ENGINE SPEED PT 1
1800 RPM
5. Touch the "Menu Button" to return to the main menu.
ENGINE SPEED PT 1
1800 RPM
6. Touch the "Menu Button" to exit the Main menu and
return to the engine parameter display.
DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 23
MORE
MORE
DIAGNOSTIC DISPLAY
FAULTS AND WARNING
Auxiliary Gage Fault
1. During normal operation the single or four parameter
screen will be displayed.
0 1500 3000
1800 RPM
ENG RPM COOL TEMP
2. The PVA Series of auxiliary gages can be attached to
the PowerView. These auxiliary gages communicate
with the Modbus master PowerView via a daisy-chained
RS-485 port. If at any time during system initialization
or normal operation an auxiliary gage should fail, the
single or four parameter screen will be replaced with
the "MLink Gage Fault" message.
1 of x
ENGINE OIL PRESSURE
GAGE NOT RESPONDING
3. To acknowledge and "Hide" the fault and return to the
single or four parameter display, touch the "Enter
Button.
1 of x
ENGINE OIL PRESSURE
GAGE NOT RESPONDING
4. The display will return to the single or four parameter
screen.
!
0 1500 3000
1800 RPM
TEMP!
ENG RPM COOL
98% 1000 RPM
LOAD RPM ENG RPM
14.2 57 PSI
BATT VOLT OIL PRES
HIDE
HIDE
1000 RPM
98%
LOAD RPM ENG RPM
!
14.2 57 PSI
BATT VOLT
OIL PRES
!